40G DAC& AOC Cable Sinovo

QSFP+ Passive Copper Cables Assembly

40Gb/s

SOQP-40G-DAC-1-20M

-

Product Features

²  4 independent full-duplex channels

²  1G to 10.5 Gbps data rate per channel

²  Support hot-pluggable

²  Metal with lower EMI

²  Excellent ESD protection

²  Available in lengths of 1, 3, and 5m

²  Single 3.3V power supply

²  RoHS Compliant and Lead-Free

²  Compliant with IEEE802.3ba

²  Compliant with QSFP+ MSA: SFF-8436

Product Selection

Part Number	Lengths	Note
SOQP-40G-DAC-1M	1m	1
SOQP-40G-DAC-3M	3m	1
SOQP-40G-DAC-5M	5m	1

Regulatory Compliance

l  ESD to the Electrical PINs: compatible with MIL-STD-883E Method 3015.7

l  RF Immunity compatible with IEC 61000-4-3

l  EMI compatible with FCC Part 15 Class B EN55022 Class B

l  RoHS compliant with 2002/95/EC 4.1&4.2 2005/747/EC

Pin-out of Connector Block on Host Board

Pin Descriptions

PIN	Logic	Symbol	Name/Description	Note
1		GND	Ground	1
2	CML-I	Tx2n	Transmitter Inverted Data Input
3	CML-I	Tx2p	Transmitter Non-Inverted Data output
4		GND	Ground	1
5	CML-I	Tx4n	Transmitter Inverted Data Input
6	CML-I	Tx4p	Transmitter Non-Inverted Data output
7		GND	Ground	1
8	LVTLL-I	ModSelL	Module Select
9	LVTLL-I	ResetL	Module Reset
10		VccRx	﹢3.3V Power Supply Receiver	2
11	LVCMOS-I/O	SCL	2-Wire Serial Interface Clock
12	LVCMOS-I/O	SDA	2-Wire Serial Interface Data
13		GND	Ground
14	CML-O	Rx3p	Receiver Non-Inverted Data Output
15	CML-O	Rx3n	Receiver Inverted Data Output
16		GND	Ground	1
17	CML-O	Rx1p	Receiver Non-Inverted Data Output
18	CML-O	Rx1n	Receiver Inverted Data Output
19		GND	Ground	1
20		GND	Ground	1
21	CML-O	Rx2n	Receiver Inverted Data Output
22	CML-O	Rx2p	Receiver Non-Inverted Data Output
23		GND	Ground	1
24	CML-O	Rx4n	Receiver Inverted Data Output	1
25	CML-O	Rx4p	Receiver Non-Inverted Data Output
26		GND	Ground	1
27	LVTTL-O	ModPrsL	Module Present
28	LVTTL-O	IntL	Interrupt
29		VccTx	+3.3 V Power Supply transmitter	2
30		Vcc1	+3.3 V Power Supply	2
31	LVTTL-I	LPMode	Low Power Mode
32		GND	Ground	1
33	CML-I	Tx3p	Transmitter Non-Inverted Data Input
34	CML-I	Tx3n	Transmitter Inverted Data Output
35		GND	Ground	1
36	CML-I	Tx1p	Transmitter Non-Inverted Data Input
37	CML-I	Tx1n	Transmitter Inverted Data Output
38		GND	Ground	1

Notes:

1.      GND is the symbol for signal and supply (power), Connect these directly to the host board signal common ground plane

2.      Vcc Rx, Vcc1 and Vcc Tx are the receiver and transmitter power supplies and shall be applied concurrent- ly. Requirements defined for the host side of the Host Edge Card Connector are listed in Table 6. Recommended host board power supply filtering is shown in Figure 4. Vcc Rx Vcc1 and Vcc Tx may be internally connected with- in the QSFP+ Module module in any combination. The connector pins are each rated for a maximum current of 500 mA.

Absolute Maximum Ratings

Parameter	Symbol	Min	Typ	Max	Unit	Ref.
Supply Voltage	Vcc	-0.5		+4.0	V
Storage Temperature	TS	-40		+85	°C
Relative Humidity	RH	0		85	%

Recommended Operating Conditions

Parameter	Symbol	Min	Typ	Max	Unit	Ref.
Power Supply Voltage	Vcc	3.13	3.30	3.47	V
Power Supply Current	Icc	-	-	100	mA
Case Operating Temperature	Tc	-5	-	+70	°C

Electrical Characteristics

Parameter	Symbol	Min	Typ	Max	Unit	Ref.
Data Rate Per Channel	BR	1	10.3	10.5	Gbps	1
Bit Error Ratio	BER			10-12		2
Input differential impedance	Zin	90	100	110	Ω

Notes:

1.       40 Gigabit Ethernet and Infiniband 4X compliant.

2.       Tested with a PRBS 2³¹-1 test pattern.

Mechanical Specifications

              SOQP-40G-DAC-1-20M

EEPROM Information

EEPROM memory map specific data field description is as below:

Arial

Arial

Contract

Shenzhen Sinovo Telecom Co. Ltd

Website:www.sinovocorp.com  Email:sales@sinovocorp.com

Tel:+86(0)0755-3295 9919 Fax:+86(0)755 3295 9918

Factory ADD: 5/F Chuang Park,Taoyuan Street,Baoan District,Shenzhen,China 518000

Head Quarter:11/F,Taibang Technology Building,Gaoxin South 4th,Science and Technology Park South,Nanshan,Shenzhen,China 518040